Installation of glass tiles and mosaics
Glass tiles and mosaics are translucent or transparent with a coating to the rear. Without a rear coating the adhesive is visible. Selecting a white adhesive intensifies the colour of the glass tile or mosaic. ASODUR-DESIGN can be used for the installation and grouting of translucent glass mosaics for equal colour. To achieve good adhesion to the glass, a highly modified adhesive should be used. Optimum results are achieved, as a rule with epoxy resin based adhesives, which can also serve as the grout for glass tiles and mosaics.
1) Modified with UNIFIX-F
2) Not for installation in underwater areas
|
LEVELLING
|
|
|
Non-sag, cement-based, rapid hardening, polymer modified, low shrinkage and creamy smoothing compound, 2 – 50 mm
|
|
|
|
Smoothing compound from 2 – 30 mm
|
|
|
|
Water repellent, rapid hardening screed mortar with high strength
|
|
|
|
PRIMING
|
|
|
Solvent free universal primer, water and alkali resistant
|
|
|
|
Epoxy resin-based barrier primer
|
|
|
|
Rapid universal epoxy-based primer
|
|
|
|
WATERPROOFING
|
|
|
Flexible, mineral-based, vapour permeable waterproof slurry for areas with increased demands in interior and exterior areas
|
|
|
|
Trowellable, chemically resistant bonded polyurethane based waterproof membrane
|
|
|
|
TILE INSTALLATION
|
|
|
White flexible adhesive for installation in thin-bed techniques 1)
|
|
|
|
White, rapid hardening flexible adhesive for installation in thin-bed techniques 2)
|
|
|
|
Chemical resistant fine grain epoxy grout, 3 component and solvent free
|
|
|
|
GROUTING
|
|
|
Mineral-based multi-function flexible grout for tiles, natural stone and other finishes from 1-10 mm joint widths with FAST TECHNOLOGY
|
|
|
|
Chemical resistant fine grain epoxy grout, three component and solvent free
|
|
|
|
Silicone sealant for movement joints
|
|
|
